Panasonic PT-LB10NTU Service Manual page 132

1. Remove the LCD block according to the section 7.12.
"Removal of LCD Block".
2. Cut the 4 LCD panel installation spindles at the position A
and remove the LCD panel.
3. Cut the 4 LCD panel installation spindles at the position B
and remove them.
Notes:
· Work carefully not to apply external force around the
spindle part by using a cutter, cutting nipper or the
like for cutting the spindle.
· Adjust the height after the spindle is cut to 1 mm or
less.
4. Attach the base plate with 4 screws.
5. Tighten the 2 screws temporarily just until new LCD panel
(with the panel attachment and panel adjuster) can be
shifted by your fingers.
PT-LB10NTU / PT-LB10NTE / PT-LB10U / PT-LB10E / PT-LB10VU / PT-LB10VE / PT-LB10SU / PT-LB10SE
6. Reassemble the projector in the reverse order of
disassembling, but leave the upper case and the screws
fixing the A-P.C.Board block as they are removed.
7. Adjust the convergence according to the section 8.4.
"Convergence Adjustment".
8. After the adjustment, while paying attention not to vary the
adjusting result, tighten the 2 screws (upper) fixing the
panel attachment temporarily with a hexagon head wrench.
Notes:
· Prepare a hexagon head wrench processed short.
· Service tool (Part No. TZSH070010), hexagon head
wrench processed short, is available.
9. Remove the LCD block again.
10. Tighten the 3 screws fixing the panel attachment.
Note:
· For PT-LB10NTU/E, the screw (lower) fixing the
panel attachment holds the installation of the LCD
panel concurrently.
11. Reassemble the projector as it was.
19