Cisco RSP7000 Installation And Configuration Manual page 43

7000 series route switch processor

Hide thumbs Also See for RSP7000:

Table of Contents

Copying a Bootable Image into a Flash Memory Card

With the Flash memory card formatted, you can now copy a bootable image into it. To copy an

image, use the following procedure, which assumes the following:

•

You have an RSP7000 with a good image in the onboard Flash SIMM so you can start the router

•

The bootable image you wish to copy to the Flash memory card exists on a TFTP server to which

you have access (know its name and have connectivity to it), and at least one interface is available

over which you can access this server

Note

setup command facility. For instructions on using this procedure, refer to the Router Products

Conﬁguration Guide (for Cisco IOS Release 10.3[9]) or Router Products Getting Started Guide (for

Cisco IOS Release 10.3[9]) publications.

•

You know the ﬁlename of the image you wish to copy into the Flash memory card

Following is the procedure for copying a bootable ﬁle (called new.image) into the Flash memory

card:

Step 1

Step 2

Note

cannot use a Flash memory card formatted on another type of system. You must reformat it to use it.

7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers

To assure access to a TFTP sever, you will need to conﬁgure at least one interface using the

Boot the router and allow it to initialize.

Insert an unformatted Flash memory card and format it using the procedure in the section

"Formatting a Flash Memory Card," and then proceed to Step 3.

If you have already formatted a Flash memory card, you can use it instead; however, you

Reference Information

Table of Contents