Cisco RSP7000 Installation And Configuration Manual page 41

Replacing a Flash Memory Card
It might become necessary for you to replace or install a Flash memory card in your RSP7000. The
RSP7000 has two PCMCIA slots: slot 0 (left) and slot 1 (right). (See Figure 9 on the following page.)
The following procedure is generic and can be used for a Flash memory card in either slot position.
A Flash memory card can be inserted and removed with the power on.
Following is the procedure for installing and removing a Flash memory card:
Step 1
Figure 9
7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers
Face the front panel of the RSP7000 (as shown in Figure 9a), and hold the Flash memory
card with the connector end of the card toward the slot.
Installing and Removing a Flash Memory Card (PCMCIA slot 1)
a
b
c
Reference Information
41