Cisco RSP7000 Installation And Configuration Manual page 4

Product Descriptions
Storing the Cisco IOS images in Flash memory enables you to download and boot from upgraded
Cisco IOS images remotely or from software images resident in the RSP7000 Flash memory,
without having to remove and replace read-only memory (ROM) devices.
Note
user-configurable jumpers on the RSP7000.
The RSP7000 contains the following components:
•
•
•
•
In addition to the system software, the RSP7000 contains and executes the following management
functions that control the system:
•
•
•
•
The high-speed switching section of the RSP7000 communicates with and controls the interface
processors on the high-speed CxBus. This switching section decides the destination of a packet and
switches it accordingly. The RSP7000 uses a 16-million-instructions-per-second (mips) processor to
provide high-speed, autonomous switching and routing.
4 7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers
The RSP7000 uses a software-controlled configuration register. There are no
Mips R4600 Reduced Instruction Set Computing (RISC) processor, used for the CPU (The CPU
runs at an external clock speed of 50 MHz and an internal clock speed of 100 MHz.)
A bank of hardware (Media Access Control [MAC]–layer) addresses for the interface ports
Most of the memory components used by the system, including onboard Flash
Air-temperature sensors for environmental monitoring (All of the logic for the environmental
monitoring functions is contained on the chassis interface card.)
Sending and receiving routing protocol updates
Managing tables and caches
Monitoring interface and environmental status
Providing Simple Network Management Protocol (SNMP) management and the console/Telnet
interface