Cisco RSP7000 Installation And Configuration Manual page 20

Installation Procedures
Note
recommend a particular slot location for the RSP7000. Processor module slots in the Cisco 7010 are
oriented horizontally
Figure 4
Step 3
Caution
Cisco 7000 (see Figure 1) or slot 3 of the Cisco 7010 (see on Figure 2) The slots are keyed for correct
installation. Forcing the RSP7000 into a different slot can damage the backplane and the RSP7000.
20 7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers
Figure 4 shows a typical processor module installation, and is not intended to indicate or
Ejector Levers and Captive Installation Screws, Cisco 7000 Orientation Shown
a
Captive
installation
screw
b
Place the back of the RSP7000 in the 7000 RSP slot and align the notches along the edge
of the carrier with the grooves in the slot. (See Figure 4a.)
To prevent damage to the backplane, you must install the RSP7000 in slot 5 of the
Bottom ejector lever
Processor Processor module
module slot
carrier guide
STOP!
on contact
c