Cisco PA-T3 Installation And Configuration Manual page 74

Installing a Port Adapter
Figure 7-4
Step 7
Step 8
Step 9
This completes the procedure for installing a new port adapter in a Cisco 7100 series router. Proceed
to Chapter 8, "Configuring the PA-T3 Interfaces," for information on configuring your port adapter
interfaces.
7-4 PA-T3 Serial Port Adapter Installation and Configuration
Aligning the Single-Width Port Adapter Between the Slot Guides
Guides
5
RCV R
I
XMT R
EN
With the port adapter halfway in the slot, connect all required cables to the port adapter.
After connecting all required cables, carefully slide the port adapter all the way into the
slot until the port adapter is seated in the router.
After seating the port adapter in the router, slide the locking tab up to the locked position
and tighten the screws. (Figure 7-1 or Figure 7-2 shows the locking tab in the locked
position.)
If the port adapter lever is not in the locked position, the port adapter is not
Note
completely seated in the router. Carefully pull the port adapter halfway out of the slot,
reinsert it, and move the port adapter lever to the locked position.
RCLK FERF RL
AIS OOF LL
FE 0 /