Pa-T3 Port Adapter Leds - Cisco PA-T3 Installation And Configuration Manual

Serial port adapter

Hide thumbs

Table Of Contents

Table of Contents

Note

individual port adapters do not. To replace port adapters in the Cisco 7000 series and Cisco 7500

series routers, and the Catalyst 5000 series switches, you must ﬁrst remove the VIP2 or

Catalyst RSM/VIP2 from the chassis and then replace port adapters as required. OIR is supported

for port adapters in the Cisco 7100 series, Cisco 7200 series, and Cisco uBR7200 series routers. Port

adapters have a handle attached, but this handle is occasionally not shown in illustrations in this

publication to allow a full view of detail on the port adapter's faceplate.

In the Cisco 7000 series, Cisco 7100 series, Cisco 7500 series, and Cisco uBR7200 series routers,

and the Catalyst 5000 series switches, there are no restrictions on slot locations or sequence;

however, in the Cisco 7200 series routers, there are speciﬁc conﬁguration guidelines that must be

observed for high-bandwidth port adapters.

For speciﬁc Cisco 7200 series routers hardware conﬁguration information and for memory

conﬁguration guidelines, refer to the document Cisco 7200 Series Port Adapter Hardware

Conﬁguration Guidelines, which shipped with your Cisco 7200 series chassis and is also available

on the Cisco Connection Documentation, Enterprise Series CD-ROM.

To determine if your Cisco 7000 series, Cisco 7100 series, Cisco 7500 series, Cisco 7200 series, or

Cisco uBR7200 series router, or Catalyst RSM/VIP2, is compatible with the PA-T3 serial port

adapter, use the show version command to display the current hardware conﬁguration of the router,

including the system software version that is currently loaded and running. You can check the

version of the default ROM image by removing the board and checking the ROM labels, or by

conﬁguring the interface or system software to boot from ROM, restarting the system, and using the

show version command to check the running version.

Use the show version command to display the current system software version. In the following

example, the running system software is Release 11.1(16)CA.

Router> show version

Cisco Internetwork Operating System Software

IOS (tm) GS Software, Version 11.1(16)CA

Synced to mainline version: 11.1(10.5)

Compiled Thu 22-May-97 14:32

If your system lacks the required system software and microcode, contact a customer service

representative for upgrade information.