Cisco PA-T3 Installation And Configuration Manual page 38

Installing a Port Adapter
Step 5
Caution
Trying to do so disrupts normal operation of the router.
Step 6
Step 7
Step 8
Figure 5-5
This completes the procedure for installing a new port adapter in a Cisco 7200 series router. Proceed
to Chapter 8, "Configuring the PA-T3 Interfaces," for information on how to configure your port
adapter interfaces.
5-4 PA-T3 Serial Port Adapter Installation and Configuration
With the metal carrier aligned in the slot guides, gently slide the port adapter halfway into
the slot.
Do not slide the port adapter all the way into the slot until you have connected all required cables.
With the port adapter halfway in the slot, connect all required cables to the port adapter.
After connecting all required cables, carefully slide the port adapter all the way into the
slot until the port adapter is seated in the router midplane.
After seating the port adapter in the router midplane, move the port adapter lever to the
locked position. Figure 5-5 shows the port adapter lever in the locked position.
If the port adapter lever does not move to the locked position, the port adapter is
Note
not completely seated in the midplane. Carefully pull the port adapter halfway out of the
slot, reinsert it, and move the port adapter lever to the locked position.
Placing the Port Adapter Lever in the Locked Position—Cisco 7206 Shown
Note: This adapter installation
applies to any port or service
adapter.
ETHERNET 10BT
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Port adapter
handle
Port adapter
lever (locked
position)
TOKEN RING