Table of Contents
Advertisement
43-726.fm Page 9 Tuesday, June 15, 1999 8:36 AM
8. Lift the base's antenna to a vertical
position.
Note: To mount the TAD directly on a
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the base.
Follow the steps under "On a Wall Plate
or Wall" on Page 8, then apply these ad-
ditional instructions for placement on a
wall.
1. Drill two holes 3
inches
(100
mm)
apart. Then thread a
screw into each hole,
letting
the
heads
5
extend about
/
16
(8 mm) from the wall.
2. Plug one end of the supplied long
modular cord into the
at the back of the base.
3. Align the bracket's keyhole slots
with the mounting screws and slide
the base downward to secure it.
5
15
/
/
16
16
15
3
/
1 6
inch
jack
TEL LINE
CONNECTING AND
CHARGING THE BATTERY
PACK
The TAD-726 comes with a recharge-
able nickel-cadmium battery pack in-
stalled
in
the
handset,
connected. Before using your phone,
you must connect the battery pack, then
charge it for about 24 hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the com-
partment. Plug the battery pack's
connector into the socket in the
compartment. The connector fits
only one way.
3. Put the battery pack in the compart-
ment.
4. Replace the cover.
but
not
9
Advertisement
Table of Contents
