Identifying Interface Addresses - Cisco PA-4C-E 1 Installation And Configuration Manual

1-port high-performance escon channel port adapter
Table of Contents

Advertisement

Overview
Figure 6
Port adapter slot 5
Port adapter slot 3
Port adapter slot 1

Identifying Interface Addresses

This section describes how to identify the interface addresses for the port adapter slots and ESCON
channel port numbers. Interface addresses specify the actual physical location of each interface port on
the router.
This address is composed of a two-part number in the format port-adapter-slot
number/interface-port-number, as follows:
Some IBM channel attach software features are configured on a virtual port. On the CIP cards installed
Note
in a Cisco 7500-series router, there are up to two physical ports, numbered 0 and 1, and a virtual port,
numbered 2. However, on the HP ESCON PA installed in a Cisco 7200 series router, the single physical
port and the virtual port are configured using the same port number identifier, number 0.
Interface ports maintain the same address regardless of whether other port adapters are installed or
removed from the slot. However, when you move a port adapter to a different slot, the first number in
the address changes to reflect the new port adapter slot number.
The HP ESCON PA is considered a high-speed port adapter; there are specific configuration guidelines
Note
that must be observed. Refer to the publication Cisco 7200 Series Port Adapter Hardware Configuration
Guidelines (Document Number 78-3471-xx), which shipped with your Cisco 7200 series chassis and is
also available on the Cisco Connection Documentation, Enterprise Series CD-ROM.
The following subsections describe the interface address formats for the supported platforms:
PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration
10
Port Adapter Slots in the Cisco 7206 Router
The first number identifies the port adapter slot in which the HP ESCON PA is installed.
The second number identifies the interface port on the HP ESCON PA, which is always numbered
as interface 0 for the HP ESCON PA.
Cisco 7200 Series Routers and Cisco 7200 VXR Routers Interface Addresses, page 11
Blank port adapter
ETHERNET 10BT
Port adapter slot 0
Port adapter slot 6
Port adapter slot 4
Port adapter slot 2
TOKEN RING
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
OL-3743-02

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa-4c-e

Table of Contents