Alarm Settings - Mebus 40715 Manual

MANUAL SETTING
Please note:
• The moon phases are calculated automatically.
End input mode automatically: If no button is pressed for 30 seconds, the device automatically
•
ends input mode. Any settings changed so far will be saved.

ALARM SETTINGS

Setting the alarm time (alarm)
In normal time display mode, briefly press the MODE button (B7) to enter alarm mode.
1.
2. Then press and hold the MODE button (B7) for several seconds until the hour display of the alarm
time starts flashing. Press the UP (B5) or DOWN/MEM (B6) buttons to first set the hour. Confirm
your setting by pressing the MODE (B7) button.
3. The minute display of the alarm time starts flashing. Press the UP (B5) and DOWN/MEM (B6)
buttons to set the minute. Confirm your setting by pressing the MODE (B7) button.
Please note:
• The alarm is automatically activated when you set the alarm time.
Activating / deactivating the alarm
• In normal time display mode, briefly press the MODE button (B7) to enter alarm mode. Press the
UP button (B5), to activate / deactivate the alarm. The bell icon (A11) appears on the display when
the alarm is active.
Alarm signal
Briefly interrupt the alarm: Press the SNZ/LIGHT button (B4). The "zZ" icon (A12) begins flashing
•
on the display. The alarm will sound again after 5 minutes.
Turn off the alarm: Press any other button to turn off the alarm for the current day. The alarm
•
sounds on the next day at the waking time set. The bell icon (A11) lights up permanently on the
display.
Please note:
• End input mode automatically: If no button is pressed for 30 seconds, the device automatically
ends input mode. Any settings changed so far will be saved.
40715-Mebus-IM-INT-V04.indb 71
71
1/3/2018 3:31 PM