Testing The Docking Station - Redback 107330 Operation Manual

Testing the Docking Station

Charging The Robot Mower
1. Attach the AC adapter cord to the AC adapter.
2. Attach the docking station connection cord to the AC adapter
and to the docking station.
3. Place the Robot Mower in the docking station for charging
ensuring that the contacts on the Robot Mower engage the
charging arms on the docking station on both sides.
Testing the Docking Station
1. Plug the adapter into an AC power outlet. The green LED
should light up.
2. Disconnect the boundary wire from the red terminal and the
green LED should blink and an alarm sounds.
3. Reconnect the boundary line into the red terminal and the
green LED lights continually which indicates that the dock is
connected correctly and ready to charge the Robot Mower.
4. Place the Robot Mower into the docking station making sure
the front of the mower is in contact with the charging arms
on the dock. Allow the mower to charge for 2 - 3 hours before
use.
Preparation for Use
1. Remove all obstacles is the mowing area before starting the
Robot Mower.
2. If the grass is taller than 2-3/8"high (60mm) it is recommended
that you mow the lawn first with a traditional lawn mower or
set the Robot Mower at its highest cutting position.
Notes on Operation
1. The Robot Mower will sense the presence of rain and return
to the docking station following a course along the boundary
line.
2. The Robot Mower will sense a battery power decline when
there is 20% or less capacity and will automatically return to
the docking station to recharge its battery.
3. Low temperature may effect the operating time.
4. Bumper sensors on the robot mower will cause it to change
direction when it encounters an obstacle.
5. Blades stop rotating in 3 seconds when the mower senses an
incline greater than 30°, the mower is lifted or in the presence
of rain.
10