Vaxcel T0616 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0616 / T0617
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Mounting Screw X2 Mounting Screw X2
#6/32 X1/2 in
#8/32X1/2 in
Tools Needed:
(1) Philip-head Screwdriver
Important to Know:
1. If you are not familiar with state and local electrical
codes, it is recommended that you consult with a
qualified electrician.
2. This fixture requires a 120 VAC, 60 Hz power
source.
3. For general safety and to avoid any possible
damage to the sensor, be sure the power is
switched "off" before adjustment.
Maximum Wattage: 24 W
Working Temperature Range:
Note: Fixture can be wall mounted or eave mounted.
FRONT
Outlet Box
Mounting
Strap
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Screw X2
#10/24 X1/4 in
(2) 1/8" wide Flat-head Screwdriver
-13°F ~ 113°F
Wall Mounted
Mounting Strap
1. Phillips-head screwdriver for attaching mounting screws to
mounting strap, mounting bracket and fixture to mounting bracket.
2. 1/8" wide flat-head screwdriver for connecting the source wires
into the wiring terminal station on the mounting bracket.
Features:
1. Energy saving LED fixture.
2.
Photocell automatically keeps the light OFF during
daylight hours and automatically turns the light ON
during evening hours.
The light will DIM to low level brightness
3.
automatically after 6 hours of evening illumination
4.
The wall switch that the light is connected to can be
used to manually override and change functionality
and settings of certain modes.
Eave Mounted
Backplate
L GND N
Page 1 / 3
Decorative cover
Light Fixture
Sensor
Fixture Mounting Screw
Decorative cover
220126