A P P E N D I X A Configuring A Catalyst 4500 Series Switch For Network Assistant Management - Cisco Network Assistant Getting Started Manual

Appendix A Configuring a Catalyst 4500 Series Switch for Network Assistant Management
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Additional Configuration Required to Manage a Community
If you have enabled clustering, disable clustering before configuring a community.
Note
If you plan to use a community, define an IP address on each switch:
Command
Step 1
Switch# configuration terminal
Step 2
Switch(config)# interface {vlan vlan_ID |
{fastethernet | gigabitethernet}
slot/interface
Step 3
Switch(config-if)# ip address ip_address
address_mask
Step 4
Switch(config-if)# end
Step 5
Switch# show running-config
Additional Configuration Required to Manage a Cluster
If you plan to use clustering, enter the cluster run global configuration command on each device, and
enter the ip address interface configuration command on the cluster commander:
Command
Step 1
Switch# configuration terminal
Step 2
Switch(config)# cluster run
Step 3
Switch(config)# cluster enable
Step 4
Switch(config)# interface {vlan vlan_ID |
{fastethernet | gigabitethernet}
slot/interface
Step 5
Switch(config-if)# ip address ip_address
address_mask
OL-6194-07
|
Port-channel number }
|
Port-channel number }
Purpose
Enter global configuration mode.
Select an interface.
(Optional) Assign an IP address to the Catalyst 4500 series.
This step is mandatory if the switch is part of
Note
community or is a cluster command switch. This step
is optional if the switch is a cluster member
candidate.
Return to privileged EXEC mode.
Verify the configuration.
Purpose
Enter global configuration mode.
Enable clustering.
Note Enable clustering on all switches that are part of the
potential cluster.
Name the cluster.
Select an interface.
(Optional) Assign an IP address to the Catalyst 4500 series
switch cluster master.
This step is mandatory if the switch is part of a
Note
community or is a cluster command switch. This step
is optional if the switch is a cluster member
candidate.
Getting Started with Cisco Network Assistant
A-3