Cisco MDS 9000 Series Troubleshooting Manual page 115

Chapter 5 Troubleshooting IP Storage Issues
S e n d c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
MDS1# show fcip profile 21
FCIP Profile 21
Internet Address is 10.10.10.2
Listen Port is 3225
TCP parameters
The following debug output is from switch MDS2.
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
(The switch is attempting to create a TCP connection on port 13. The creation port must match the TCP
listen port on the remote end point.)
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
MDS2(config-if)# peer-info ipaddr 10.10.10.2 port 3225
(This changes the start active connection port to match the default port 3225.)
Or you can use this command:
MDS2(config-if)# no peer-info ipaddr 10.10.10.2 port 13
(Removing port 13 will also set it to the default of 3225.)
MDS2# show int fcip 21
fcip21 is trunking
Hardware is GigabitEthernet
Port WWN is 20:42:00:0b:5f:d5:9f:c0
Peer port WWN is 20:42:00:05:30:00:59:de
Admin port mode is auto, trunk mode is on
Port mode is TE
vsan is 1
Trunk vsans (allowed active) (1-2)
Trunk vsans (operational)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
Using Profile id 21
Peer Information
OL-5183-02, Cisco MDS SAN-OS Release 1.3
SACK is disabled
PMTU discover is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 300 ms
Maximum number of re-transmissions is 4
Advertised window size is 64 KB
port1: 1340:FCIP21: Start TCP listener with peer: 10.10.10.2:3225
port1: 1341:FCIP: Create a new listener object for 10.10.11.2:3225
port1: 1342:FCIP: Create FCIP Listener with local info: 10.10.11.2:3225
port1: 1343:FCIP21: Create a DE 0xd802d140 for this tunnel
port1: 1344:FCIP21: Bind the DE 0xd802d140 [1] to tunnel LEP 0x80111570
port1: 1345:FCIP21: Start the active connection [1] to 10.10.10.2:13
port1: 1346:FCIP21: Create a DE 0xd802cdc0 for this tunnel
port1: 1347:FCIP21: Bind the DE 0xd802cdc0 [2] to tunnel LEP 0x80111570
port1: 1348:FCIP21: Start the active connection [2] to 10.10.10.2:13
port1: 1349:FCIP21: Active Connect creation FAILED [1]
port1: 1350:FCIP21: Delete the DE [1]0xd802d140
port1: 1351:FCIP21: Delete the DE object [1] 0xd802d140
port1: 1352:FCIP21: Try 7 to bring up the tunnel
port1: 1353:FCIP21: Start the bringup tunnel timer, timeout: 64000
port1: 1354:FCIP21: Active Connect creation FAILED [2]
port1: 1355:FCIP21: Delete the DE [2]0xd802cdc0
port1: 1356:FCIP21: Set lep operation state to DOWN
port1: 1357:FCIP21: Delete the DE object [2] 0xd802cdc0
port1: 1358:FCIP21: Try 8 to bring up the tunnel
port1: 1359:FCIP21: Start the bringup tunnel timer, timeout: 128000
(interface GigabitEthernet2/1)
Peer Internet address is 10.10.10.2 and port is 3225
(interface GigabitEthernet2/1)
(1-2)
(1-2)
()
()
Cisco MDS 9000 Family Troubleshooting Guide
Troubleshooting FCIP Connections
5-21