Cisco MDS 9000 Series Troubleshooting Manual page 104

Troubleshooting FCIP Connections
S e n d c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Use the show fcip profile command to verify that the configuration of the profiles are correct. The IP
address and TCP port are the ports to listen on, and both are adjustable in the FCIP profile. The example
below displys all default values that are adjustable while configuring the FCIP profile.
MDS1# show fcip profile
-------------------------------------------------------------------------------
ProfileId
-------------------------------------------------------------------------------
28
MDS1# show fcip profile 28
FCIP Profile 28
Listen Port is 3225
TCP parameters
Use the show interface fcip command to verify that the interface FCIP tunnel is established and that
traffic is passing through.
MDS1# show interface fcip 28
FCIP28 is trunking
Hardware is GigabitEthernet
Port WWN is 20:5e:00:05:30:00:59:de
Peer port WWN is 20:5e:00:0b:5f:d5:9f:c0
Admin port mode is auto, trunk mode is on
Port mode is TE
(The FCIP tunnel will be either E (ISL or TE (EISL) passing through multiple VSANs.)
vsan is 1
Trunk vsans (allowed active) (1-2)
Trunk vsans (operational)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
Using Profile id 28
(This is the FCIP profile and the Gigabit Ethernet being used by the FCIP tunnel.)
Peer Information
(This is the remote end point's IP address and listening port.)
Special Frame is disabled
(The Special Frame for verification of a remote MDS is not being used.)
Maximum number of TCPconnections is 2
(The default is 2 TCP connection being used, one for class F and other for class 2 and 3.)
Time Stamp is disabled
(The timestamp can be activated under the interface FCIP.)
B-port mode disabled
TCP Connection Information
(The above is class F traffic.)
Data connection: Local 10.10.10.2:3225, Remote 10.10.11.2:65521
(The above is class 2,3 traffic.)
Cisco MDS 9000 Family Troubleshooting Guide
5-10
Ipaddr
10.10.10.2
SACK is disabled
PMTU discover is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 100 ms
Maximum number of re-transmissions is 4
Advertised window size is 64 KB
(interface GigabitEthernet2/8)
Peer Internet address is 10.10.11.2 and port is 3225
2 Active TCP connections
Control connection: Local 10.10.10.2:3225, Remote 10.10.11.2:65519
TcpPort
3225
(1-2)
(1-2)
()
()
Chapter 5 Troubleshooting IP Storage Issues
OL-5183-02, Cisco MDS SAN-OS Release 1.3