Table of Contents
Advertisement
Install the Adapter Brackets
Figure 3: Installing the Adapter Bracket on a 19-inch Rack
Note
1
2
• For a 23 inch (584.2 mm) ANSI configuration, remove the preinstalled brackets and place the 23-inch
adapter bracket against one side of the mux/demux panel.
Figure 4: Installing the Adapter Bracket on a 23-inch Rack
1
2
• For an ETSI configuration, remove the preinstalled brackets and place the Z-shaped adapter bracket
against one side of the mux/demux panel.
Install Cisco NCS 1000 32-Channel Mux/Demux Patch Panel
6
The cable ties shown in the image are optional. Use the cable ties to route the USB 3.0 cable
to right side of the mux/demux panel to the NCS 1010 EITU.
12-24x 0.5-Inch Phillips Pan Head Screws
#12 Lock Washers
23-Inch Rack Adapter Bracket
12-24x 0.5-Inch Phillips Pan Head Screws
Install Cisco NCS 1000 32-Channel Mux/Demux Patch Panel
Advertisement
Table of Contents
