SPL Phonitor xe Quick Start Manual page 4

Phonitor xe – Quickstart
Headphone output selection
By using the F/R switch you can select an output – Headphone outputs on the
front (F) or Headphone outputs on the rear (R) of the Phonitor xe.
Phonitor Matrix settings
By using the MATRIX switch you can activate (ON) or deactivate (OFF) the
Phonitor Matrix.
The Phonitor Matrix creates a speaker-like listening experience on headphones. When listening to speakers sound
coming from one side is also perceived with the ear on the opposite side. The Phonitor Matrix calculates the time
and level diff erences with their specifi c frequency responses to deliver a true rendition of a speaker playback.
With the CROSSFEED switch you adjust the interaural level diff erence.
The size, reflections and absorption characteristics of a room influence the level with which a sound coming from a
speaker is perceived with the opposite ear. The Phonitor Matrix provides 6 positions to adjust this level.
With the ANGLE switch you adjust interaural time diff erence.
The placement of the speakers determine the stereo width. In a standard stereo speaker setup the angle is typically
30°. The Matrix off ers three more angles. The wider the speakers are apart the higher the time diff erence.
The MODE switch selects the playback – mono, stereo and stereo with an
extremely fi ne balance (LATERALITY).
Learn IR remote control
The volume potentiometer of the Phonitor xe is motorized and can be operated
by any infrared (IR) remote control.
Press the IR PGM VOLUME button (infrared programmable volume).
Power LED now lights up brighter and the Volume control moves fully counter clockwise.
Point your remote control towards the VU display and push the button you wish
lower
to use to the volume. The Power LED lights up once per push. Press the
same button repeatedly until the Power LED lights up three times within a short
interval – programming of this button is then completed.
Point your remote control towards the VU display and push the button you wish
increase
to use to the volume. The Power LED lights up once per push. Press
the same button repeatedly until the Power LED lights up three times within a
short interval – programming of this button is then completed.
Learn mode ends automatically aft er the second button is learned.
6
Crossfeed Switch
Phonitor Matrix Switch
Angle Switch
Phonitor xe
Off On
MATRIX
USB Coax
RCA Optical
XLR AES
Stereo
Mono
MODE
VOLTAiR
120V DC Audio Rail
Mode Switch
Laterality Headphone Output Selection
Voltage Selection:
C A U T I O N
1. Remove Fuse Holder
2. Exchange Fuses
RISK OF ELECTRIC SHOCK
3. Flip Over 4. Reinstall
D O N O T O P E N
Fuses: 230V AC: T 500 mA L 250 V
115V AC: T 1 A L 250 V AVIS: RISQUE DE CHOC ÉLECTRIQUE • NE PAS OUVRIR
~ 115V AC / ~230V AC, 50 Hz / 60 Hz, P max. 45 W
L
Phonitor xe
IR
PGM R
Serial
Number Balanced Standard
Refer to
Manual
Made in Germany HEADPHONES OUTPUTS ANALOG SOURCES
IR PGM Volume
Phonitor xe – Quickstart
VU Meter
ON
VU
+6
0 +12 F R
Balanced Standard
Headphone Amplifier
Power LED
DIP SWITCHES W I R I N G
ON BOTTOM SIDE: XLRs: balanced, Pin 2 = Hot (+)
For unbalanced operation
1 ON: HP Out +22dB
bridge Pin 3 to GND.
2 ON: RCA -10dBV to 0dBu
RCAs: Unbalanced, Tip = Hot (+)
COAX
R L AES OPTICAL USB
DIGITAL SOURCES
7
EN
DE