Table of Contents
Advertisement
THRU
EXP PEDAL
The optional SZ-E2 Expression Pedal (sold
separately) can be connected to this terminal to
control the volume.
FOOT SW 1, 2
An optional SZ-P1 Foot Switch (sold separately)
can be connected to each terminal to control
various functions.
AUX IN (input level 0.5 Vrms, 6 kΩ)
Other instruments such as a sound generator
can be connected to this terminal, and the sound
will be output from the Keyboard's speakers. To
receive monaural sound, connect the other in-
strument to the R/R+L terminal. (Do not connect
the L terminal.)
LINE OUT (output level 1.5 Vrms, 600 Ω)
By connecting an external high-power amplifier,
the sound can be reproduced at a high volume.
To output monaural sound, connect the external
equipment to the R/R+L terminal. (Do not con-
nect the L terminal.)
MIDI
These terminals are for connection to another
MIDI instrument.
FOOT CONTROLLER
An optional SZ-FC2 Foot Controller (sold
separately) can be connected to this terminal to
control various functions.
MIC
A microphone can be connected to this terminal
for voice output through the speakers.
• The effects applied to the MIC INPUT and the
microphone volume can be set.
EXP PEDAL
2
– FOOT SW –
OUT
IN
R
MIDI
1
L
R
Ú
R + L
Ú
R + L
LINE OUT
COMPUTER
By connecting this terminal to the serial port of
a computer, performance data can be ex-
changed. Use the switch to select the type of
computer.
• Be sure that the power to this instrument is
turned off when connecting to a computer or
when changing the switch setting.
Caution:
Failure to turn off the power before changing
the switch setting may result in malfunction.
• When no computer is connected, or when a
MIDI interface is used, the switch should be
set to MIDI.
Connection to a Macintosh series computer
Use an ACCESSORY CABLE (SZ-JJAP1: sold
separately) to connect the COMPUTER terminal
of this instrument to the modem port or printer
port of a Macintosh Series computer. Set the
switch to MAC.
• Set the MIDI interface clock of the Macintosh
software to 1 MHz.
• Do not remove the core at either end of the
cable.
Connection to a PC
Use an ACCESSORY CABLE (SZ-JJAT1: sold
separately) to connect the COMPUTER terminal
of this instrument to the RS232C terminal of a
PC. Set the switch to PC2.
• The MIDI driver included with the cable should
be installed in the computer. (Refer to the
manual accompanying the cable.) This MIDI
driver is not compatible with Windows NT or
Windows 2000.
• Do not remove the core at either end of the
cable.
* All product and company names are trademarks or
registered trademarks of thir respective owners.
MIDI
FOOT
PC2
CONTROLLER
COMPUTER
L
MIC
AUX IN
MAC
PC1
Advertisement
Table of Contents
