Philips AVENT SCD630 Manual page 11

1
Eco 20°C
1
Eco 20°C
1
Eco 20°C
Positioning the baby monitor
4 Press the on/off button on the parent unit to switch on the parent unit.
- The display goes on, the linking image appears on the display and the
link light lights up red. The parent unit starts to search for the baby unit.
- When the parent unit and baby unit are linked, the link light lights up
green on the parent unit and one or more bars appear on the display.
Note: It takes less than 10 seconds to establish the link between the
parent unit and the baby unit.
- When the baby unit is turned off, the parent unit will show the out of
range image. Make sure that the baby unit is switched on.
- If no connection has been established, the link light turns red, the parent
unit beeps three short beeps every 20 seconds and the out-of-range
image appears on the display.
Warning: The cord of the baby unit presents a
potential strangulation hazard. Make sure that
the baby unit and its cord are at least 1 meter /
3.5 feet away from your baby. Never place the
baby monitor inside the baby's bed or playpen.
11
English