Hammerhead HLLT16 Manual page 16

OPERATION
Determine the miter and bevel angles
for cutting crown molding
a. Press the MTR/BVL button to
display the miter angle; "MTR" will
show in the LCD display (Fig. 12).
b. Press the MTR/BVL button again
to display the bevel angle; "BVL"
will show on LCD display (Fig. 13).
c. Record the MTR/BVL values and
set the miter and bevel angles on
the compound miter saw.
d. To recall the MTR or BVL angles,
press the hold button for 3
seconds go back to the last figure.
e. To return to the normal mode,
press the MTR/BVL button again.
NOTE:
If the angle measured is out of allowable
range of spring or corner angle, " -----" will
appear in the LCD display and the tool will
revert to the normal measuring mode after approximately 10 seconds. The allowable
range for spring angles is 25.1° to 60.9°; for corner angles it is 59° to 151°.
WARNING
When cutting crown moldings, follow all instructions in the operating manual of
the compound miter saw.
16
12
MTR
13
16" DIGITAL ANGLE FINDER
BVL