Plasmacluster Ion Spot Mode; Air Flow Direction Setting; Fan Speed Setting; Humidification Setting - Sharp KI-G75EU Operation Manual

PLASMACLUSTER ION
SPOT MODE
Use this mode when you want to remove adhering
odour, germs, and other substances from clothes,
sofas and curtains.
The main unit operates with the higher fan speed
for 8 hours.
♪
NOTE
• Emits high-density Plasmacluster Ions only in
the forward direction.
• When the operation finishes, the main unit will
return to the prior operation mode.
• It is not able to change the fan speed during this
mode.
• The Plasmacluster Ion can not be turned "OFF".
AIR FLOW DIRECTION
SETTING
The swing angle of the Front Lou-
ver can be adjusted.
SWING
♪
NOTE
• If the Swing button is pressed when the louver
is swinging,
• Do not change the angle by holding Front /Back
Louver, otherwise it may lead to failure or injury.
KI-G75EU_10_languages_A.indb 8
• It is able to
change the front
louver direction
during this mode.
STOP
♪ ♪
EN-8

FAN SPEED SETTING

♪ ♪ ♪ ♪
AUTO POLLEN SLEEP LOW
AUTO :
The fan speed is automatically switched depending
on the amount of impurities in the air.
POLLEN :
The DUST SENSOR sensitivity is automatically set
to "HIGH" and quickly detects impurities such as
dust and pollen and clean the air powerfully.
SLEEP :
The Main Unit will operate quietly, and the fan
speed is automatically switched depending on the
amount of impurities in the air.
The Front Display go off automatically.
(When light control is set to "Auto". (page 10,11))

HUMIDIFICATION SETTING

ON
♪
NOTE
• When operating with Humidification ON in the
modes in the table below, the unit automatically
controls humidity by sensing temperature and
humidity. (Except MAX / MED / LOW mode.)
ALL MODE
Temperature
(Except MAX / MED /
LOW / SLEEP)
~18 ºC 65 %
18 ºC~24 ºC 60 %
24 ºC~ 55 %
♪ ♪ ♪
MED MAX
OFF
♪ ♪
Humidity
SLEEP
MODE
65 %
65 %
60 %
2019-02-18 10:51:45