Preparation; Filter Installation; Operation; Start/Stop - Sharp KC-G61R Operation Manual

PREPARATION

FILTER INSTALLATION

1
Remove the Back Panel.
Back Panel
2
Remove the plastic bag
from the each filter.
HEPA Filter
Deodorizing Filter

OPERATION

START/STOP

START STOP

CLEAN ION SHOWER MODE

The unit releases Plasmacluster ions with strong airflow
and collects dusts while decreasing static electricity for
10 minutes. After that, the DUST sensor sensitivity is
automatically set to "HIGH"and quickly detects impurities
and clean the air powerfully for 50 minutes.
NOTE
• When the operation finishes after
60 minutes, the unit will return
to the prior operation mode. It is
able to change the other mode
during this mode.
• The Plasmacluster Ion can not
be turned "OFF". (Ref.E-10)
Always be sure to remove the
power plug from the wall outlet.
3
Install the filters in the correct order as
shown.
HEPA Filter
Tag
Deodorizing Filter
4
Install the Back Panel.
Click
2
1
3
3
NOTE
• When replacing the filter, making a memo of the start of
use date is recommended.
INTELLIGENT MODE
(KC-G61R / KC-G51R)
The fan speed is automatically controlled depending on the 7
detection. (Ref.E-1)
AUTO MODE
(KC-G41R)
The fan speed is automatically controlled depending on the
5 detection. (PM2.5 / Usual dust / Temperature /Humidity /
Light)
NOTE
• Front Display, Cleanliness Monitor and Air Outlet LED
automatically switch ON and OFF based on room
brightness. (When light control is set to "Auto". Ref.E-11)
E-7
PLASMACLUSTER ION
SPOT MODE
Use this mode when you want to remove adhering odor,
germs, and other substances from cloths, sofas and curtains.
Adjust Front Louver manually.
NOTE
• Emits highdensity Plasmacluster Ions only in the forward
direction.
• Discharges stronger air for 8 hours. When the operation
finishes, the unit will return to its prior operation mode.
• The Plasmacluster Ion can not be turned "OFF". (Ref.E-10)

SELECTING MODE

POLLEN SLEEP LOW MED MAX
NOTE
SLEEP
The unit will operate quietly, and the fan speed is
automatically switched depending on the amount of impurities
in the air.
The Front Display, Cleanliness Monitor and Air Outlet LED
go off automatically.
(When light control is set to "Auto". Ref.E-11)
POLLEN
The DUST SENSOR sensitivity is automatically set to "HIGH"
and quickly detects impurities such as dust and pollen and
clean the air powerfully.

CHILD LOCK

Operation of the operation panel will be locked.
ON CANCELLATION
more more
3 sec. 3 sec.

HUMIDIFICATION SETTING

REFILLING THE WATER TANK

1
Remove
2
the Water Tank.
2
Fill the Water Tank
with the tap water.
3
To prevent leaks ,
securely tighten the
Tank Cap.
4
Install
Click
the Water Tank.
1
ON OFF
NOTE
When operating with Humidification ON in the modes in
the table below, the unit automatically controls humidity by
sensing temperature and humidity. (Except MAX / MED /
LOW mode.)
Humidity
Temperature
ALL MODE
(Except MAX / MED / LOW / SLEEP)
~18 ºC 65 %
18 ºC~24 ºC 60 %
24 ºC~ 55 %
E-8
1
2
SLEEP
MODE
65 %
65 %
60 %