Storage And Transport; 11: Electrical Connection; Disposal And Recycling; Troubleshooting - Scheppach bgs 700 Translation From The Original Instruction Manual

Maintenance
There are no parts inside the equipment which
require additional maintenance.
10. Storage/Transport
Store the equipment and accessories out of chil-
dren's reach in a dark and dry place at above freez-
ing temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
m Attention! Unplug the machine!
The appliance must unconditionally be secured
against falling or turning down during transport.
The appliance can be lifted on the left and right
grinding wheel / belt sander cover. Power cable, flex-
ible lamp shaft etc. should not be used for transport
purpose.
11. Electrical connection
The installed electric motor is factory connected
ready for operation.
The connection meets the applicable VDE and DlN
regulations.
The connection made by the customer as well as
any extension cables used must comply with all
relevant regulations.
Connection and repair work on the elctric equipment
must be carried out by a qualified technician only.

13. Troubleshooting

Problem
Motor
doesn't start
Machine
gets slower during work.
Sanding belt comes off
the drive pulleys.
The wood gets burnt
during
sanding.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible Cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
Too much pressure put on the work-
piece.
Belt does not run straight.
a) Sanding disc or belt covered with
grease.
b) Excessive pressure on workpiece.
Important note
The motor rating is S 1. This means that when over-
loaded it switches off automatically. After a cooling
period (can vary) you may switch it on again.

Disposal and recycling

12.
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Never
place defective equipment in your household refuse.
The equipment should be taken to a suitable collec-
tion center for proper disposal. If you do not know the
whereabouts of such a collection point, you should
ask in your local council offices.
Action
a-d) Replace all damaged parts before you use
your machine again.
e) Contact your local service centre. Every at-
tempt to carry out a repair, can be dangerous if
it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a)Replace disc or belt.
b) Reduce pressure on workpiece.
GB
23 / 152