Cleaning And Maintenance; Storage/Transport; Electrical Connection - Scheppach BGS700 Translation Of Original Instruction Manual

Grinding
• Place the workpiece onto the workpiece support (8)
and slowly guide the workpiece towards the grind-
ing wheel (6) at the desired angle to the point where
workpiece and grinding wheel make contact.
• Move the workpiece slightly back and forth to pro-
duce an optimal grinding result. This way the grind-
ing wheel (6) will be evenly worn. Allow the work-
piece to cool down occasionally.
Grinding/sanding with the belt
• Always hold the workpiece firmly during grinding/
sanding.
• Do not exert excessive pressure.
• The workpiece should be moved on the belt to pre-
vent the paper wearing on one side.
• Important! Pieces of wood should always be sanded
with the grain to prevent them splitting.
Using the grinding wheel dresser
The grinding wheel dresser is a tool for straightening
of grinding wheels.
• Press lightly against grinding wheel – without cre-
ating sparks. Move the dresser sideways over the
entire width of wheel.
m Attention! Always wear safety goggles.
m Attention!
If the grinding wheel or the grinding/sanding belt be-
comes jammed during operation, please remove the
workpiece until the tool reaches its top speed again.
9.

Cleaning and maintenance

Always pull out the mains power plug before starting
any cleaning work.
Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
• We recommend that you clean the device immedi-
ately each time you have finished using it.
• Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
26 | GB
Maintenance
There are no parts inside the equipment which require
additional maintenance.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: grinding medium, carbon brushes, sharp-
ening wheel, angle gauge, v-belt
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. Spare parts and accessories can be
obtained from our Service Centre.

10. Storage/Transport

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing temper-
ature. The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original packaging.
m Attention! Unplug the machine!
The appliance must unconditionally be secured against
falling or turning down during transport.
The appliance can be lifted on the left and right grind-
ing wheel / belt sander cover.
Power cable, flexible lamp shaft etc. should not be
used for transport purpose.

11. Electrical connection

The installed electric motor is factory connected ready
for operation. The connection meets the applicable
VDE and DlN regulations. The connection made by the
customer as well as any extension cables used must
comply with all relevant regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
www.scheppach.com