Flex ORE 3-150 EC Original Operating Instructions page 15

ORE 3–150 EC / ORE 5–150 EC
Re-attach microfilter box.

Number of oscillations control
The thumb wheel can be used to steplessly
vary the number of oscillations from 1 (low)
to 6 (high) even while the power tool is
running.
As a result, the grinding speed can
be optimally adjusted to the particularly
material and the working conditions.
Switching on and off
Switch power tool on or off by pressing

on/off switch.
CAUTION!
Following a power failure, the switched-on
power tool will start running again.
Operating instructions
WARNING!
Hold the electric power tool by the insulated
grip surfaces only!
CAUTION!
When the power tool is switched off, the
grinding tool continues running briefly.
Switch on the sander and place the

whole sanding sheet on the surface
to be processed.
Applying moderate pressure, move

the sander evenly over the workpiece.
The sanding result is determined

primarily by the selection of the correct
sanding sheet, the selected number
of oscillations and the contact pressure.
Replace sanding sheets in good time.

An excessive increase in the contact

pressure will not increase the grinding
performance, but will increase the wear
on the electric power tool and the
sanding tool.
For further information on the manufac-
turer's products go to www.flex-tools.com.
15