Kenmore 790.75503 Use & Care Manual page 34

General
Cleaning
FEATURE OVERVIEW
• To Remove and Replace
Oven Door
• To Remove and Replace
Storage Drawer
To Remove and Replace Right Oven Door
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers. You may
have to apply a little downward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage
the hinge supports. Keep pulling the bottom of the door toward you while rotating the top
of the door toward the range to completely disengage the hinge levers.
4. To replace the door, reverse the door removal steps. Make sure the hinge supports are fully
engaged before unlocking the hinge levers.
The door is heavy. After removing door, lay it flat on the floor with its inside
facing down.
o
upport normal position
.. Lock engaged
for door remova
Hinge Slot .
Door removea
from range
Lef_ Glide
Furb downwith flnilr
Fig. 1
Pullup with firmer
To Remove and Replace Storage Drawer
To Remove Storage Drawer:
1. Open the drawer to the fully opened position.
2. Locate the glide lever on each side of drawer; pull up on the left glide lever
and push down on the right glide lever (see figure 1).
3. Pull the drawer away from the range.
I_ht Glide
To Replace Storage Drawer:
1. Pull the bearing glides to the front of the range (see figure 2).
2. Align the drawer glides with the slots on the bearing glides.
3. Push the drawer into the range until the glides levers "click" (approx. 2 in.).
Pull the drawer open again to seat it into position.
4 If you do not hear the glide levers "click" or if the drawer does not
feel seated, remove it and repeat steps 1 through 3. Doing so will
minimize damage to the bearing glides. Do not try to force the drawer into
place.
Fig. 2
34