Surface Cooking - Kenmore 790.75503 Use & Care Manual

Surface
Cooking
FEATURE OVERVIEW
• Flame Size
• Proper Burner
Adjustment
• Placement of Burner
Bases and Caps
Flame Size
For most cooking, start on the highest control setting and then turn to a lower one to
complete the process, Use the table below as a guide for determining proper flame size for
various types of cooking. The size and type of utensil used and the amount of food being
cooked will influence the setting needed for cooking.
For deep fat frying, use a thermometer and adjust the surface control knob accordingly. If the
fat is too cool, the food will absorb the fat and be greasy, If the fat is too hot, the food will
brown so quickly that the center will be undercooked. Do not attempt to deep fat fry too much
food at once as the food will neither brown nor cook properly.
RIGHT
*Flame Size
High Flame
Medium Flame
Low Flame
Type of Cooking
Start most foods; bring water to a boil; pan broiling
Maintain a slow boil; thicken sauces, gravies; steam
Keep foods cooking; poach; stew
WRONG
*These settings are based on using medium-weight aluminum pans with lids. Settings
may vary when using other types of pans.
Never extend the flame beyond the outer edge of the utensil. A higher flame simply wastes
heat and energy, and increases your risk of being burned by the flame.
Proper Burner Adjustments
The color of the flame is the key to proper burner adjustment. A good flame is clear, blue and
hardly visible in a wellqighted room. Each cone of flame should be steady and sharply defined.
Adjust or clean burner if flame is yellow-orange. To adjust the flame see the Installation
Instructions and to clean burner, see instructions under General Cleaning.
Make sure each burner cap
is properly aligned and
level.
Turn the burner on to
determine if it will light. If
the burner does not light,
contact a Sears Service
Center. Do not service the
sealed burner yourself.
Placement of Burner Bases and Caps
Place the burner base over each gas opening,
matching the burner base size with the gas
opening size. Place the burner cap on each
burner base, again matching the cap size to
the burner base size. The cap for the each
Burner has a inner locating ring which locates
the burner cap in the center of the burner.
Grate
Pin
Grate /
Head
Orifice
Electrode must be
located propedy in slot
of eache Burner Head
14