Technical Data; Machine Features - Festool T 18+3 Li Original Operating Manual

T 18+3 Li
GB
3 Intended use
Cordless drill suitable for
– drilling in metal, wood, plastic and similar mate-
rials,
– inserting and tightening screws
– use with Festool batteries BPC and BPS of the
same voltage.
The user is liable for improper or non-in-
tended use; this also includes continuous in-
dustrial operation.
4

Technical data

Cordless drill
Motor voltage
Idle engine speed*
Max. torque
Adjustable torque**
Chuck clamping range
Max. drill diameter
Tool holder in drill spindle
Weight excl. battery pack, incl.
CENTROTEC
* Speed specifications with fully charged battery
pack.
** The maximum speed is reduced in the lower
torque stages (values in counterclockwise rotation).
5

Machine features

[1-1] Buttons for releasing the battery pack
[1-2] Bit store
[1-3] On/Off switch
[1-4] Right/left switch
[1-5] LED lamp
[1-6] Gear switch
[1-7] Drilling symbol
[1-8] Screwdriving symbol
[1-9] Drilling/Fastening selector switch
[1-10] Capacity display
[1-11] Belt clip
12
T18+3 Li
18 V
1st gear 0 - 450 min
2nd gear 0 - 1500 min
Soft mate- 35 Nm
rial (wood)
Hard mate- 50 Nm
rial (metal)
1st gear 0.8 - 8 Nm
2nd gear 0.5 - 6 Nm
1.5 - 13 mm
Wood 45 mm
Metal 13 mm
1/4 ''
1,1 kg
[1-12] Torque thumbwheel
[1-13] Insulated gripping surfaces (grey shaded
area)
Accessories shown or described are sometimes not
included in the scope of delivery.
The specified illustrations appear at the beginning
of the Operating Instructions.
6 Commissioning
6.1 Belt clip
The belt clip allows a shot-term securing of the de-
vice in the work clothes. Insert the belt clip on the
designated side, right or left, and fix it with the
screw [1a].
6.2 Changing the battery pack [2]
-1
The capacity display [1-10] automatically displays
-1
the charge state of the battery pack [1-3] when the
ON/OFF switch is actuated:
7 Settings
Risk of injury

Always switch off the power tool before adjusting
settings!
7.1 Changing direction of rotation [1-4]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Changing gear [1-6]
• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
7.3 Fastening
Adjust the switch so that its marking [1-9] faces the
screw symbol [1-8].
Adjust the torque accordingly at the torque wheel
[1-12].
Position 1 = low torque
Position 25 = high torque
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge bat-
tery pack before further use.
CAUTION