Maintenance Instructions; Troubleshooting - Kärcher K 5 Premium Full Control Plus Operator's Manual

Care and maintenance
DANGER
Risk of electric shock.
Prior to all work on the appliance,

switch off the appliance and pull the
power plug.
Clean the sieve in the water
connection
Clean the sieve in the water connec-
tion regularly.
Remove coupling from the water

connection.
ATTENTION
The sieve must not be damaged.
Illustration
Pull the sieve out using flat pliers.

Clean the sieve under running water.

Reinsert the sieve into the water con-

nection.
Changing the batteries of the
trigger gun
The batteries are depleted if
nothing or the following is
shown on the display of the
high-pressure gun.
Two batteries or accumulators
of the size AAA are required.
Illustration
Push the locking slide.

Open battery compartment.

Remove the batteries.

Insert new batteries and observe the

correct orientation of the terminals.
Close battery compartment.

Dispose of the used batteries ac-

cording to the local provisions.
14 English

Troubleshooting

DANGER
Risk of electric shock. Turn off the appli-
ance and remove the mains plug prior to
performing any care and maintenance
work.
Repair work and work on the electrical
components may only be performed by
an authorised customer service.
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
Appliance is not running
Push the lever of the trigger gun, the

device will switch on.
Check whether the voltage indicated

on the type plate corresponds to the
voltage of the mains supply.
Check the mains connection cable

for damages.
Motor overloaded, the motor circuit

breaker has tripped.
Turn off the appliance "0/OFF".
–
Allow the device to cool down for one
–
hour.
Switch on the device and put it into
–
operation again.
If the malfunction occurs repeatedly,
have the device checked by the cus-
tomer service.
Appliance does not start, motor
Voltage reduction due to weak mains
supply or when using an extension ca-
ble.
Upon switch-on, push the lever of the

trigger gun first and then switch the
power switch to "I/ON".
hums