Shutting Down And Clean-Up - Kärcher K 5 Premium Full Control Plus Operator's Manual

Operation with detergent
* Optional accessories
Most KÄRCHER detergents can be
bought ready to use in a Plug 'n' Clean
detergent bottle.
DANGER
When using detergents, the material
data safety sheet issued by the deter-
gent manufacturer must be adhered to,
especially the instructions regarding
personal protective equipment.
Note: Detergent can only be added
when the device is operated in low pres-
sure mode.
Illustration
Remove the cap of the Plug 'n' Clean

detergent bottle.
Push the detergent bottle with the

opening pointing downwards into the
connection for the Plug 'n' Clean de-
tergent.
Turn the 3-in-1 multi jet spray lance

to detergent nozzle "MIX".
Note: This will mix the detergent with
the water stream.
Using the +/- buttons of the high-

pressure gun, set the desired deter-
gent concentration.
Recommended cleaning method
Spray the detergent sparingly on the

dry surface and allow it to react, but
not to dry.
Spray off loosened dirt with the high

pressure jet.
After operation with detergent
Remove the Plug 'n' Clean detergent

bottle from the intake and close it
with the lid.
For storage, put the detergent bottle

into the retainer with the cap pointing
up.
To rinse, operate the device for

about 30 seconds in detergent
level 1.
12 English
Interrupting operation
Release the lever of the trigger gun.

Lock the lever of the trigger gun.

Illustration
Put the trigger gun with the spray

lance into the parking position.
During longer breaks (more than 5

minutes), also turn the appliance off
using the "0/OFF" switch.
Finish operation
CAUTION
Only separate the high-pressure hose
from the trigger gun or the device when
there is no pressure in the system.
ATTENTION
When disconnecting the supply or high
pressure hose, warm water may leak
from the connections after operation.
Release the lever of the trigger gun.

Turn off tap.

Press the lever of the high-pressure

gun for 30 seconds to release any re-
maining pressure in the system.
Release the lever of the trigger gun.

Lock the lever of the trigger gun.

Detach the appliance from the water

supply.
Turn off the appliance "0/OFF".

Disconnect the mains plug from the

socket.