Functional Description - Makita BVC340 Instruction Manual

(2) Avoid storing battery cartridge in a
container with other metal objects such as
nails, coins, etc.
(3) Do not expose battery cartridge to water
or rain.
A battery short can cause a large current
flow, overheating, possible burns and
even a breakdown.
6. Do not store the tool and battery cartridge in
locations where the temperature may reach or
exceed 50 ﾟ C (122 ﾟ F).
7. Do not incinerate the battery cartridge even if
it is severely damaged or is completely worn
out. The battery cartridge can explode in a fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
SAVE THESE INSTRUCTIONS.
Tips for maintaining maximum battery life
1. Charge the
completely discharged.
Always stop tool operation and charge the
battery cartridge when you notice less tool
power.
2. Never recharge a fully charged
cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room
temperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F).
Let a hot battery cartridge cool down before
charging it.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the cleaner is switched off and
•
the battery cartridge is removed before adjusting or
checking function on the cleaner.
Installing or removing battery cartridge
Fig.1
To remove the battery cartridge, withdraw it from the
cleaner while sliding the button on the front of the
cartridge as shown in the figure.
To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it
into place. Always insert it all the way until it locks in
place with a little click. If you can see the red part on the
upper side of the button, it is not locked completely. Insert
it fully until the red part cannot be seen. If not, it may
accidentally fall out of the cleaner, causing injury to you
or someone around you.
Battery protection system
The cleaner is equipped with the protection system,
which automatically cuts off the output power for its long
service life.
battery cartridge
The cleaner may stop during operation when the cleaner
and/or battery are placed under the following situation.
This is caused by the activation of protection system and
does not show the cleaner trouble.
When the remaining battery capacity becomes low:
•
Switch action
Fig.2
To start the cleaner, simply press the "HIGH/LOW" button.
To switch off, press the "OFF" button. To change the
cleaner speed, press the "HIGH/LOW" button. The first
press on this button is for high speed and the second
press for low speed and then each press on this button
repeats the high/low speed cycle alternatively.
ASSEMBLY
CAUTION:
Always be sure that the cleaner is switched off and
•
before
the battery cartridge is removed before carrying out
any work on the cleaner.
Any work with the battery cartridge being installed
•
on the cleaner may cause a personal injury or
damage to the objects around the cleaner.
battery
Installing dust bag
1
1. Dust outlet
2. Dust bag joint
3. Pins
4. Dust bag
011113
Hold the square section of the dust bag joint and fit the
pins inside the dust bag joint to the notches in the dust
outlet of the cleaner and then insert and turn it clockwise
all the way until it stops.
Fig.3
At this time, make sure that the fastener part on the dust
bag faces upward.
NOTE:
When the dust bag joint and the ring inside the dust
•
bag come off, install as follows.
(1)
6
Recharge the battery cartridge.
2
3
4
Align the dust bag joint with the seam of the
dust bag and install it so that its protrusion
faces upward.