Operation - Makita BVC340 Instruction Manual

Fig.4
(2) Tighten the ring inside the dust bag firmly so
that the pins and the ring are positioned as
shown in the figure.
Fig.5
Installing the shoulder strap
Fig.6
Attach one end hook of the shoulder strap onto the ring in
the front of the cleaner and thrust the other end of the
strap through the band of the dust bag and then attach
the other end hook as shown in the figure..
Adjusting the shoulder strap
Fig.7
To adjust the length of the shoulder strap, pull it out to
your desired length and pull the strap in the direction of
arrow as shown in the figure.
Connecting the hose
CAUTION:
Do not force the hose to bend it and/or stamp it.
•
Forcing and/or stamping the hose may cause
deformation or damage to the hose.
Do not pull the hose to carry the cleaner. Pulling
•
the hose may cause deformation or damage to the
hose.
B
1
2
1. Dust outlet
2. Power tool
011119
Insert the "A" end of the hose to the suction opening of
the cleaner and turn it clockwise all the way until it locks.
Attach the cuff on the "B" end of the hose and then
connect it to the dust outlet of an power tool.
Replacing the front cuff
Change the front cuff of the hose according to the dust
outlet size of a power tool you use.
Fig.8
To remove the front cuff, hold the hose and turn it
counterclockwise.
To mount the front cuff, turn it clockwise and then screw
it in until it stops.

OPERATION

WARNING:
Do not use the shoulder strap when working in a
•
high place.
When using the cleaner as a stationary cleaner,
•
place it on a flat and stable surface
Vacuum Cleaner
Fig.9
When using the cleaner as a portable cleaner,
cross-hanging the shoulder strap before the breast is
difficult to drop the cleaner.
Fig.10
NOTE:
Long cut-off decorative paper that may be
•
produced by plaster board cutting work depending
on the conditions of workpiece to be cut and that
may be stuffed inside the hose may cause the hose
suction blocking. When this occurs, change the
cutting depth setting of power tool to deeper depth,
which will relieve the hose suction blocking.
CAUTION:
When the dust bag is just new, dust may come out
•
of its surface. Using it a few times will minimize the
dust leak from the surface.
Operation of the cleaner with a nozzle or a
dust bag being installed
WARNING:
Always be sure that the cleaner is switched off
•
and the battery cartridge is removed before
installing or removing the nozzle or any other
attachment on the cleaner. Failure to switch off
and remove the battery cartridge may result in
A
serious personal injury.
NOTE:
Before the blower mode operation immediately
•
after the cleaner mode operation, remove all
remaining dust from the cleaner due to possible
blow out of dust .
Using as a blower
Fig.11
Install the nozzle onto the outlet (air vent) without fail.
To install the nozzle, fit the pin protruding from the inside
of nozzle to one of the cleaner notches and then turn
the nozzle clockwise securely.
To remove the nozzle, turn counterclockwise and pull it
out.
Direct the top point of the cleaner and then switch on.
7