Table of Contents
Advertisement
34 | English
To measure, briefly press the measuring button (2) [ ]. The measured value will be
shown at the bottom of the display.
Repeat the above steps for each subsequent measurement. The last
measured value is at the bottom of the display, the penultimate meas-
7.620
m
ured value is above it, and so on.
0.0°
8.890
m
10.160 m
11.430 m
Continuous measurement
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated approx. every half a second. You
can, for example, move a desired distance away from a wall while reading off the current
distance at all times.
Select the continuous measurement mode
To switch on the laser beam, briefly press the measuring button (2) [ ].
Move the measuring tool until the desired distance is shown at the bottom of the display.
Briefly pressing the measuring button (2) [ ] will interrupt the continu-
ous measurement. The current measured value will be shown at the bot-
tom of the display. Pressing the measuring button (2) [ ] once more
-64°
will start the continuous measurement again.
Continuous measurement automatically switches off after five minutes.
11.623 m
Area measurement
Select the area measurement mode
Then measure the width and length one after the other as with a length measurement.
The laser beam remains switched on between the two measurements. The distance to be
measured flashes in the indicator for area measurement
The first measured value is shown at the top of the display.
After the second measurement has been completed, the area will be
3.810 m
automatically calculated and displayed. The end result is shown at the
0.0°
5.080 m
bottom of the display, while the individual measured values are shown
2
above it.
19.355 m
Volume measurement
Select the volume measurement mode
1 609 92A 4RG | (15.11.2018)
.
.
.
.
Bosch Power Tools
Advertisement
Table of Contents
