What You Receive With Your Cnc Router; Where To Locate Your Cnc Router - Laguna Tools Smartshop II Series Manual

5. Controller/Electrical cabinet.
The Controller/Electrical cabinet is located on the side of the machine enclosure
and houses all the electrical components for controlling and powering the
machine.
6. Caterpillar track.
The caterpillar track runs along the side of the machine and across the gantry in
a trough and carries all the electrical cables and the spindle cooling tubes if
water-cooled spindle is fitted.
7. Water pump.
The water pump provides coolant for the router spindle motor (if fitted). Running
the router spindle without the cooling pump running can lead to spindle bearing
failure.
8. Vacuum table.
Vacuum table has 6 zones for flexible use.
9. Tool changer.
Tool changer has 8 stations to accommodate a large range of tools.
10. Oiler.
The oiler connects to all the relevant slides on the machine and when pumped by
hand will lubricate all the relevant slides.
Additional instructions for the use of the CNC machine.
Like all machines, there is danger associated with the machine. Injury is
frequently caused by lack of knowledge or familiarity. Use this machine with
respect. If normal safety precautions are overlooked or ignored, serious personal
injury may occur. As the CNC is under the control of the onboard machine
controller, it is important that you are clear of the cutter when operating the
machine.
What you will receive with the machine.
What is supplied with your machine will depend on the specification of the
machine and extras that you order.
Where to locate your machine.
Before you unpack your machine, select the area where you will use your
machine. There are no hard-and-fast rules for its location, but below are a few
guidelines.
1. There should be an area around the machine suitable for the length of wood
that you will be machining.
2. Adequate lighting. The better the lighting, the more accurate and safely you
will be able to work
3. Solid floor. You should select a solid flat floor, preferably concrete or
something similar.
4. Close to power source and dust collection.
9