Assembly Instructions - Kärcher G 4000 OH Manual

n Do not leave machine running unattended.
n Avoid tipping machine on its side.
SAVE THESE INSTRUCTIONS
CAUTION
When connecting to water sup-
ply mains, local regulations of
your municipal water company
must be observed. In some areas connect-
ing directly to public drinking water supply
may require a backflow prevention device.
This is to ensure that there is no feedback
of chemicals into the water supply. Use a
suitable system separator manufactured
by KÄRCHER; or, as an alternative, a sys-
tem separator as per EN 12729 Type BA,
Water flowing throught a system separator
is considered non-drinkable.
n Garden hose must be at least 16mm
diameter.
Description
A
Knob
B
5/16" X 1 3/4
Bolt
C
5/16" X 2" Bolt
D
Hose Holder
E
High Pressure
Hose
F
Spray Gun
6 English
IMPORTANT SAFETY INSTRUCTIONS
WATER SUPPLY (Cold Water Only)

ASSEMBLY INSTRUCTIONS

Hardware (included)
Purpose
Joint Assembly
Joint Assembly
Hose Holder Assembly
Hose Holder Assembly
Spray Gun Assembly
Spray Gun Assembly
n Flow rate of water supply must not fall
below 15 L/Min. (Liters per minute)
n Flow rate can be determined by running
the water for one minute into an empty 19
L container.
n The water supply temperature must not
exceed 104°F/40°C.
n Never use the pressure washer to draw
in water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
n Always prevent debris from being drawn
into the unit by using a clean water source.
Use additional water filter.
n Do not operate pressure washer without
the water turned on.
Illustration
Qty
2
2
1
1
1
1