Table of Contents
Advertisement
Performance Verification Procedures
Input Channels vs. Model
Conventions
1–2
When performing the procedures in this section, be aware that some TDS models
refer to input channels Ch 3 and Ch 4 as Aux 1 and Aux 2 respectively. Where
appropriate, both names will appear in the procedure, for example, Ch 3 (Aux 1).
The channel names for the various TDS models are shown below.
TDS Model
TDS 540B, 644B, 684B, 754A, and 784A
TDS 520B, 620B, 680B, 724A, and 782A
Throughout these procedures the following conventions apply:
H Each test procedure uses the following general format:
Title of Test
Equipment Required
Prerequisites
Procedure
H Each procedure consists of as many steps, substeps, and subparts as required
to do the test. Steps, substeps, and subparts are sequenced as follows:
1. First Step
a. First Substep
H First Subpart
H Second Subpart
b. Second Substep
2. Second Step
H In steps and substeps, the lead-in statement in italics instructs you what to
do, while the instructions that follow tell you how to do it, as in the example
step below, "Initialize the oscilloscope" by doing "Press save/recall SETUP.
Now, press the main-menu button...".
TDS 500B, TDS 600B & TDS 700A Performance Verification and Specifications
Channel Names
Ch 1, Ch 2, Ch 3, and Ch 4
Ch 1, Ch 2, Aux 1, and Aux 2
Advertisement
Table of Contents
