Hub Bearings; Inflating The Tire Tube - HOMCOM 371-041BK Owner's Manual

HUB BEARINGS

Hub bearings require special thin wrenches called cone
wrenches
the adjustment if you have any doubts.
❶ Check to make sure neither locknut is loose.
❷ To adjust, remove wheel from scooter and loosen the
locknut on one side of the hub while holding the bearing
cone on the same side with a cone wrench.
❸
❹
❺ Re-check that the wheel can turn freely without excessive
side play.

INFLATING THE TIRE TUBE

WARNING!
•
•
causing injury to the rider. Always use a hand pump to
Do not
❶ Remove the valve cap and add air.
❷
❸ Spin the wheel and check for high and low areas.
❹
❺
not, release some air and repeat steps three through six.
❻ Check for dirt in the valve cap or stem. Clean dirt from cap
or stem.
❼ Securely replace the valve cap on the stem.
27