Sauna Heater Stone; Connection Of The Sauna Heater To The Mains - Helo 1712-45-171817 Quick Instructions

Sauna heater stone

- Sauna stones should be piled sparsely in order to enhance ventilation between the stones. Do not bend the
heating elements together or against the frame.
- Stones are piled so that they cover the heating elements. Do not, however, pile a large heap of stones on the
heating elements. For a sufficient amount of stones refer to Table on page 3. Any small stones in the
package of stones must not be piled on the sauna heater.
- Structural clay tiles are not allowed. They may cause damage to the sauna heater that will not be covered by
the warranty.
- Do not use soapstone as sauna rocks. Any damages resulting from this will not be covered by the stove warranty.
- Do not use lava stone as sauna rocks. Any damages resulting from this will not be covered by the stove warranty.
- DO NOT USE THE HEATER WITHOUT STONES.
Timer
The sauna heater is controlled by operating a 12-hour timer with three operating zones.
The timer is set by twisting the knob clockwise until the desired operating zone is reached. When operating, the timer gradually
travels counter-clockwise towards the zero position.
1. 0 position. The sauna heater is not on.
2. Operating zone 1–3 hours. Set on this zone, the sauna heater heats up at full power
while the sauna thermostat controls the temperature.
3. Preset zone 1–9 hours. Set on this zone, the sauna heater can be preset to turn on
after a certain period of time. The heating elements will not heat up when the timer is
within this zone.
Before turning the sauna heater on, make sure the sauna room is suitable for taking a
sauna bath.
The timer operates better if it is first turned further than the desired time and then turned
back to the desired time. If the switch has not travelled back to 0 position after finishing
bathing, turn it to 0 manually.
Thermostat
The thermostat knob is next to the timer knob. The further right (clockwise) the timer is
switched, the higher the temperature will rise in the sauna room. The best way to find
the ideal temperature is to first turn the thermostat fully on the right and let the temperature
rise to the desired temperature. Subsequently, turn the thermostat knob slowly counter-
clockwise until you hear a gentle clicking sound. If you want to readjust the temperature,
turn the thermostat gradually until the temperature is ideal.
The thermostat will not operate correctly if the stones are piled too densely or they are too
small. Please refer to section "Sauna heater stones"
The thermostat has an integrated temperature limiter with a reset switch
next to the thermostat knob.
ROHS
Instructions for environmental protection
This product must not be disposed with normal household waste at the end of its life cycle. Instead, it should be
delivered to a collecting place for the recycling of electrical and electronic devices.
The symbol on the product, the instruction manual or the package refers to this.
The materials can be recycled according to the markings on them. By reusing, utilising the materials or by otherwise
reusing old equipment, you make an important contribution for the protection of our environment. Please note that
the product is returned to the recycling centre without any sauna rocks and soapstone cover.
Please contact the municipal administration with enquiries concerning the recycling place.

Connection of the sauna heater to the mains

The sauna heater must be connected to the mains by a qualified electrician and in compliance with current regulations. Sauna
heater is connected with a semi-permanent connection. Use H07RN-F (60245 IEC 66) cables or a corresponding type. Other
output cables (signal lamp, electric heating toggle) must also adhere to these recommendations. Do not use PVC insulated
cable as a connection cable for the sauna heater.
0
1
9
2
3
8
1
7
2
6
3
5
4
PALAUTUS RETUR RESETTING
+
2