Drying - Siemens CM924G1 1B Series User Manual And Installation Instructions

Table of Contents

Advertisement

en Drying
18  Drying
To prevent residual moisture, dry the cooking compart-
ment following microwave-only operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
Do not use the appliance if there is water on the
cooking compartment floor.
Wipe away any water on the cooking compartment
floor before operation.
19  Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
19.1 Detaching the door outer pane
WARNING ‒ Risk of injury!
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
Open the appliance door.
1.
2.
Place a folded-up tea towel
Undo
​ ⁠ and remove the screws
3.
right of the appliance door.
4.
Close the appliance door.
Use two hands on the handle to pull the front pane
5.
​ ⁠ upwards and remove it
24
​ ⁠ in the appliance door.
​ ⁠ on the left and
​ ⁠ .
18.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the "Drying" function.
Allow the appliance to cool down.
1.
2.
Remove dirt from the cooking compartment.
Wipe away the water in the cooking compartment.
3.
Dry the cooking compartment.
4.
To dry the cooking compartment, leave the appli-
ance door open for 1 hour.
To use the "Drying" function, set "Drying".
Set the front pane down on a level surface with the
6.
door handle facing down.
7.
WARNING ‒ Risk of serious harm to health!
If the screws are undone, the safety of the appliance
can no longer be guaranteed. Microwave energy
may escape.
Never undo the screws.
Never unscrew the screws on the frame.
8.
WARNING ‒ Risk of serious harm to health!
By removing and refitting the intermediate pane, the
safety of your appliance can no longer be guaran-
teed.
Never bend the bending tabs upwards.
Never remove the intermediate pane.
19.2 Attaching the door outer pane
1.
Attach the front pane downwards into the left- and
right-hand retainers
Push the front panel in at the top.
2.
​ ⁠
​ ⁠ .

Advertisement

Table of Contents
loading

Table of Contents