Table of Contents
Advertisement
wLSN
5.13.1
Installation Considerations
NOTICE!
Glass break detectors are intended only as a component of a
perimeter protection system. You should always use a motion
detector together with a glass break detector.
For the best detector performance, select a mounting location
that is:
–
–
–
–
–
–
Avoid mounting the detector:
–
–
–
–
5.13.2
Sensitivity Settings
1.
2.
3.
Bosch Security Systems, Inc.
within 7.6 m (25 ft) of the protected glass
within clear view of the protected glass
at least 2 m (6.5 ft) from the floor
at least 1 m (3 ft) from forced-air ducts
at least 1 m (3 ft) from sirens or bells greater than 5 cm
(2 in.) in diameter
on a window frame if any heavy window covering is
present
in a corner
on the same wall as the protected glass
on free-standing posts or pillars
in rooms with noisy equipment such as air compressors,
bells, and power tools
If the front housing is attached, carefully open the service
door (Item 3, Figure 5.19, Page 50).
Enable the EVENT and ALARM LEDs for test purposes by
sliding the LED ENABLE switch (Item 8, Figure 5.19,
Page 50 in the direction of the arrow (above the switch).
An orange flag protrudes from the side of the detector.
Use Table 5.24 to determine the appropriate sensitivity
setting for your application.
System Reference Guide
wLSN Devices | en
F01U138553 | 01 | 2010.05
51
Advertisement
Table of Contents
