Hyundai H-FH2-F11MC Instruction Manual page 10

*The image is provided as a reference and may differ from the actual instrument
1. Operation mode switch
2. Instrument housing
3. Air flow outlet grate
7. OPERATION OF THE DEVICE
1. Do not install the appliance on unstable or uneven surfaces.
2. To avoid electric shock, do not insert or remove the plug from the outlet with wet hands.
3. For the normal operation of the device, the voltage level in the network must be sufficient in accordance
with the technical parameters specified on the device.
4. The device must be installed strictly vertically.
5. Do not use the device in areas with a high dust content. Otherwise, a large amount of dust in the device
may cause it to fail and refuse warranty service.
ATTENTION!
Never use the appliance in a horizontal or inclined position.
8. CLEANING AND MAINTENANCE
Make sure that the appliance is de-energized before starting preventive cleaning.
Recommendations for regular cleaning:
Disconnect the appliance from the mains by unplugging the power cord from the electrical outlet, allow the
appliance to cool down, then wipe the housing with a soft, slightly damp cloth.
For cleaning, it is not recommended to use detergents, including those with abrasive compositions.
Do not damage the surface of the appliance with sharp objects.
9. TROUBLESHOOTING
If it is impossible to fix these malfunctions with these methods, contact the authorized service center.
Malfunction
The device is connected
to the mains, operating
mode is set to heating but
device
doesn't work.
Heating is not good enough
10. STORAGE
Complete all requirements of chapter CARE AND CLEANING
Keep the appliance in a cool, dry place.
11. UTILIZATION RULES
Possible cause
No power
Electrical circuit of heating
element malfunction
Malfunction in circuit breaker
Defective thermostat
Defective heating element
Faulty temperature limiter
Power cord is broken
Low voltage in
power network
Low heating temperature is set
on thermostat
Defective heating element
Solution
Check whether the power
supply is disconnected from
the device and, if necessary,
connect device to power supply
Contact an authorized service center
Change the circuit breaker
Contact an
authorized service center
Contact an
authorized service center to fix it
Check power network
Set the temperature higher on
thermostat
Contact an authorized service center
10
IM2022