Symbols On The Device; For Your Safety - Magnetic MHTM FlowMotion mWing Operating Instructions Manual

mWing
Safety
2.5

Symbols on the device

2.6

For your safety

14
Warning of dangerous electrical voltage!
The warning sign indicates hazardous areas with dangerous elec-
trical voltage. Non-observance of the warning signs causes se-
vere injuries or death. The work to be carried out may only be
carried out by a qualified electrician or an electric safety expert.
This warning sign is fixed at the following point:
›
At the terminals, under the cover.
Mortal danger by electric voltage!
Touching live parts can be lethal. Damaged insulation or dam-
aged parts may be fatal.
›
If the insulation or any parts are damaged, switch off the pow-
er supply at once and initiate repair.
›
Only qualified electricians or electrical safety experts may
work on the electrical system.
›
Switch off power supply and secure against re-activation be-
fore performing any work. Test for absence of voltage.
›
Perform electrical installation in accordance with the applica-
ble regulations.
›
Install protective devices that are prescribed by national regu-
lations, such as e.g. residual current circuit breakers. These
protective devices must be provided by the customer.
›
Observe the information on the type plate.
›
Close all covers after work has been carried out.
›
Keep moisture and dust away from live parts. Penetrating
moisture and dust can lead to a short circuit.
›
If the electrical connection is made during precipitation, e.g.
rain or snow, prevent the penetration of moisture by means of
suitable protective covers.
›
During or after a lightning strike into the system, there is dan-
ger to life if the components are touched or during a stay in
the immediate vicinity of the system. When installing out-
doors, do not install and mount the pedestrian gate during
thunderstorms.