Voltage Specification; Working Mode - Flash LASER 10W RGB GOBO User Manual

User Manual •Instrukcja Obsługi

5.2 Voltage specification

Input Voltage
100/240V
5.3 Connecting power supply
The connection is performed using
power cable with PowerCon connector
( i n c l u d e d ) . T h e d e v i c e m u s t b e
operated by qualified personnel.

6. WORKING MODE

MODE Key: Click to switch a MODE.
Prg Mode: Prg list Mode (sequential playback function), play according to the order of
editing Prg files, short press „UP" and „DOWN" to change Prg list, long press „UP" and
„DOWN" to change working folder.
ILDA Mode: ILDA play Mode. Loop on a single ILDA file (with an extension of ILDA, case
insensitive), short press „UP" and „DOWN" to change ILDA
file, long press to change working folder.
Audio Mode: Audio Mode, play internal Audio programs, press UP and DOWN to change
the acoustic sensitivity.
Auto Mode: Auto Mode.Play internal automatic programs.
Dmx Mode: Dmx Mode, press UP and DOWN to change the Dmx address.
Phasic seet: Phase setting, press „UP" and „DOWN" to change the phase.
Size: Modify the drawing Size.
Total Power
CAUTION! In the case of cable damage do not attempt to repair.
Replacement or repair can be made only on the manufacturer or by
a person with appropriate permissions.
120W
Make sure that the power grid supply
parameters are consistent with device
parameters and limitations are not
exceeded.
Frequency
50/60Hz