Step 3-Prepare The Workstation - HP xw6000 Installation Instructions Manual

Å
WARNING: To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper
workstation, setup, posture, and health and work habits for computer users, and provides important
electrical and mechanical safety information. This guide is located on the Web at
http://www.hp.com/ergo and/or on the documentation CD if one is included with the product.
Ä
CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning
these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal
object.
Ä
CAUTION: Installing the processor incorrectly can damage the system board. Have an HP authorized
reseller or service provider install the processor. If you plan to install it yourself, read all the instructions
carefully before you begin.
✎
NOTE: HP accessories are for use in HP workstation products. They have been extensively tested for
reliability and are manufactured to high quality standards. HP, therefore, warrants only those accessories
that are manufactured or sold by HP.
Step 1—Gather your supplies
Ensure that you have all necessary supplies before you begin this procedure:
■ Processor option kit
■ Microsoft® Windows® operating system CD or Red Hat Linux box set
■ Printed copies of relevant workstation documentation, which can be found at
http://www.hp.com/support/workstation_manuals
■ Static-free mat (to prevent possible damage from static electricity)
■ Static strap (to prevent possible damage from static electricity)
Step 2—Upgrade the system BIOS
Before installing a second Xeon processor on your workstation, see
http://www.hp.com/go/bizsupport and verify that you have the latest BIOS installed on your
workstation. Also, ensure that your workstation has the latest service pack installed. This ensures that you
have the necessary updates for your new processor to work properly.
✎
NOTE: Failure to install the latest BIOS could cause your workstation to fail when you install your new
processor.
Step 3—Prepare the workstation
Your workstation documentation includes instructions for disassembling and preparing the workstation for
installation, including powering down the workstation, disconnecting power from the workstation, opening
the access panel, and removing components.
For product-specific information, refer to the Service and Technical Reference Guide for your HP
workstation at http://www.hp.com/support/workstation_manuals.
Second Xeon processor installation
2/12