Fujitsu FD-1000AT User Manual page 14

Installation Method 2
1. Remove the four screws that secure the KVM holder in place.
2 Insert the 4-port switch into the open space in the rear top panel, making sure that
the 4-port KVM switch's connectors face out from the rear of the Console Drawer.
3. Fasten the 4-port KVM switch in place with the four new screws inserted from
underneath the rear panel.
4. Reattach the KVM holder to the rear top panel with the four screws removed in step
1.
Installation Method 2: 4-port KVM switch Assembly Diagram
1 0
An extra four 3 x 6 mm flathead screws (not provided) are
required to fasten the 4-port KVM switch in place.
It is not necessary to remove the Console Drawer from the guide
rails if there is sufficient workspace above and below the unit after
it has been attached to the rack. If the Console Drawer needs to
be removed, reverse the [Installing Console Drawer] operation on
page 7.
(viewed from the left rear)