Installing The 4-Port Kvm Switch (Crt/Kb Switcher) - Fujitsu FD-1000AT User Manual

Installing the 4-port KVM Switch (CRT/KB Switcher)

Three methods are used for installing the 4-port KVM switch (Installation Methods 1 - 3).
After removing the rubber feet from this device 4-port KVM switch, use the appropriate
installation method for this device configuration.
Refer to [Connecting to Ports] on page 13 for details on connecting the 4-port KVM
switch.
CAUTION
Installation Method 1
8
The 4-port KVM switch will not fit inside of this device unless the
rubber feet have been removed.
To avoid electric shocks and/or short circuits, make certain that
the power cable of this device is not plugged in.
Since this device can cause injury if it falls or tips over, be certain
to only work on a stable surface.
This device contains the components that store and release high
voltage electric charges. Only work on this device after checking
that it has been electrically discharged.
Some metal edges may be sharp. Be careful to not cut yourself.
To avoid damaging this device, do not place foreign objects
(including metal objects, water, and/or liquids) inside it. Also, do
not touch except as necessary.
To avoid damage, only licensed engineers should install the
4-port KVM switch.
Philips screwdrivers (large, small) are required to install the
Console Drawer. Have these ready before proceeding.
The screws for installation method 2 are not included with the
4-port KVM switch. These four 3 x 6 mm flathead screws must be
separately obtained.
No extra screws are needed.
It is not necessary to remove the Console Drawer from the guide
rails if there is sufficient workspace above the unit after it has
been attached to the rack.
If the Console Drawer needs to be removed, reverse the
[Installing Console Drawer] operation on page 7.