Table of Contents
Advertisement
Configuration | System | Management Protocols | SNMP
Configuration | System | Management Protocols | SNMP
This screen lets you configure and enable the SNMP (Simple Network Management Protocol) agent.
When enabled, you can use an SNMP manager to collect information from the VPN 3002 but not to
configure it.
To use SNMP, you must also configure an SNMP Community on the Configuration | System |
Management Protocols | SNMP Communities screen.
The settings on this screen have no effect on sending system events to SNMP trap destinations (see
Configuration | System | Events | General and Trap Destinations). For those functions, the VPN 3002
acts as an SNMP client.
Figure 8-6
Enable SNMP
Check the box to enable SNMP. The box is checked by default. Disabling SNMP provides additional
security.
SNMP Port
Enter the port number that SNMP uses. The default is 161, which is the well-known port number.
Changing the port number provides additional security.
Maximum Queued Requests
Enter the maximum number of outstanding queued requests that the SNMP agent allows. Minimum is 1,
default is 4, maximum is 200.
Apply / Cancel
To apply your SNMP settings, and to include the settings in the active configuration, click Apply. The
Manager returns to the Configuration | System | Management Protocols screen.
VPN 3002 Hardware Client Reference
8-6
Configuration | System | Management Protocols | SNMP Screen
Chapter 8
Management Protocols
OL-1893-01
Advertisement
Table of Contents
