Table of Contents
Advertisement
intimus DIS 150/230
Page 6
1 Foreword
Congratulations on your purchase of a intimus cutting mill
Model intimus DIS 150/230
Only original intimus replacement parts respectively purchased parts complying with the original state may
be used.
Guarantee claims are only valid if no changes are made to the original state of the cutting mill.
We assume no liability for damage caused by failure to comply with these instructions or by inappropriate
behaviour.
This technical manual may not be duplicated or passed on to third parties, either totally or partially.
1.1 Supplied technical documentation
The following documentation was supplied together with the machine:
Operating manual for the cutting mill, including
- Electrical circuit diagram
- Replacement parts lists
- Operating manual for the purchased parts (motor, safety switch, ...)
1.2 Factory number
The machine number is located on the nameplate on the right of the upper part.
This machine number must be stated when making any technical inquiries.
1.3 Declaration of conformity
Valid accident prevention regulations for the plastics industry VBG 4, VBG 5, VBG 22 and valid standards
DIN EN 292 Parts 1+2, DIN EN 953, DIN EN 954 Part 1, DIN EN 1050, DIN EN 1088, DIN EN 12012-1, DIN
VDE 0113 Part 1 and DIN VDE 0113 have been taken into consideration.
EC Machine Directive (2006/42/EC)
intimus International GmbH
Tel.: +49 (0)7544 60-0
Bergheimer Str. 6-12, D-88677 Markdorf
Fax: +49 (0)7544 60-265
Internet: www.intimus.com
E-Mail: sales.de@intimus.com
Advertisement
Table of Contents
