Table of Contents
Advertisement
DISASSEMBLY INSTRUCTION
2-14: CAPSTAN DD UNIT (Refer to Fig. 2-14-A)
1.
Remove the Capstan Belt.
2.
Remove the 3 screws
1
.
3.
Remove the Capstan DD Unit.
1
1 1
• Screw Torque: 4 ± 0.5kgf•cm
NOTE
1.
In case of the Capstan DD Unit installation, apply the
silicon bond (TSE3843-W) on the position Fig. 2-14-B
correctly. (If no silicon bond applied, abnormal noise will
be heard on the deck operation.)
(Refer to Fig. 2-14-B, C)
Applied position of
silicon bond
Be careful not to apply the silicon
bond to the Pinch Roller.
Capstan DD Unit
Capstan Belt
Capstan DD Unit
Fig. 2-14-A
Fig. 2-14-B
Silicon Bond
Main Chassis
Fig. 2-14-C
2-15:
MAIN CAM/PINCH ROLLER CAM/JOINT GEAR
(Refer to Fig. 2-15-A)
1.
Remove the E-Ring
2.
Remove the E-Ring
Cam and Joint Gear.
NOTE
1.
In case of the Pinch Roller Cam and Main Cam
installation, install them as the circled section of Fig. 2-
15-B so that the each markers are met. (Refer to Fig.
2-15-B)
Pinch Roller Cam
Marker
Main Cam
2-16: LOADING GEAR S/T UNIT (Refer to Fig. 2-16-A)
1.
Remove the E-Ring
Gear.
2.
Remove the Main Rod, Tension Lever, Loading Arm S
Unit and Loading Arm T Unit.
Main Rod
Tension Lever
- 8 -
, then remove the Main Cam.
1
, then remove the Pinch Roller
2
1
Main Cam
2
Pinch Roller Cam
Joint Gear
Fig. 2-15-A
Fig. 2-15-B
and remove the Main Loading
1
1
Main Loading Gear
Loading Arm T Unit
Loading Arm S Unit
Fig. 2-16-A
Advertisement
Table of Contents
